Milltronics CVCC Manuel d'instructions télécharger pdf (Page 42)

PRODUCT MESSAGES

Product messages transmitted from the Host to the BIC-II must be in the following format :

SOM ➟ BIC-II I.D. ➟ PORT ➟ MSG ➟ EOM

The BIC-II removes the ‘SOM’, ‘BIC-II I.D.’, ‘PORT’ and ‘EOM’, data fields and then adds the product ‘som’

and ‘eom’ data fields. The converted message is then transmitted to the product.

The format of the messages transmitted from the product(s) to the BIC-II will be dependant upon the product

type. The BIC-II converts the product message by removing the ‘som’ and ‘eom’ data fields and adding the

‘SOM’, ‘BIC-II I.D.’, ‘PORT’ and ‘EOM’ data fields.

When a converted message is received from a duplex product, the message is immediately transmitted to the

host device. A converted message from a simplex product is transmitted to the host only in response to a

RAM Table or FIFO Buffer Request.

Refer to the appropriate product instruction manual

for the format of the applicable product messages.

PROGRAM

TIP

Performing a new ‘Self Test’ after an ‘Error

Reset’ is recommended. If the cause of any

persistent error cannot be determined contact

Milltronics or your distributor.

■

PL-371 8 – 10

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

Pas de commentaire

Milltronics CVCC Manuel d'instructions Page 42