Milltronics CVCC Manuel d'instructions télécharger pdf (Page 28)

RESET

Reset may be used to reset the BIC-II to the factory BIC mode software setup. When a Reset message is

transmitted from the host, the BIC-II resets:

» Delimiters to off.

» Format to normal.

» Product Mode to AiRanger Series level product.

A Reset is not required after a BIC-II power interruption.

Transmit the following message from the host to the BIC-II to activate a Reset.

Data ASCII Example

Field Character Description

SOM STX start of message

BIC-II I.D. 1 BIC-II #1 (e.g.) (range = 1 to 8)

MT 26 turn delimiters on

EOM CR end of message

No response is received by the host as a result of transmitting this message.

DELIMITERS

Delimiters are helpful when ASCII messages between the BIC-II and host are being monitored on a terminal

or data analyzer (especially during communications software development).

With Delimiters off (factory default setting), each message transmitted from the BIC-II to the host, consists of

a continuous ASCII character string. When Delimiters are on, each data field is separated by a (,) comma. (A

comma is not inserted preceding the EOM field).

Delimiters are automatically reset to "off" during a BIC-II power up. Delimiters (when activated) may be

manually turned "off" using the RESET message.

Transmit the following message from the host to the BIC-II to activate Delimiters.

Data ASCII Example

Field Character Description

SOM STX start of message

BIC-II I.D. 1 BIC-II #1 (e.g.) (range = 1 to 8)

MT 27 turn delimiters on

EOM CR end of message

No response is returned to the host as a result of this message.

When the Delimiters mode is activated, the data fields of all messages transmitted

from the host to the BIC-II must also be separated by commas.

PL-371 7 – 4

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 75 76

Pas de commentaire

Milltronics CVCC Manuel d'instructions Page 28